americanmachineandgear You could say that I have an attraction to Neodymi Just slightly over 50 Millionths of an Inch of run Not a bad finish if I do say so, myself. 🤩 👍💪🇺🇸⚙️ Aircraft parts. Unobtainium. This was Turning Tues Spinning a 16mm diameter on an 3.65mm eccentricity PSA - Never buy your seats on Temu. It’s a scam. S Some friends you always look forward to hanging ou If you’re not rubbing, you’re not racing. This isn No limits pushed. No chances taken. 😏 #normalday Digging out the 40+ year old hold down clamps for Making more of those toothy spinny things for peop Moving right along. Another 100 left to go. 👍💪🇺🇸⚙ If the material isn’t large enough to punch throug Clearance is clearance. Right?😎 👍💪🇺🇸⚙️ American Okay. Well, looks like I need to be much more care Initial batch run of Churchkey PLUS, Churchkey MIN Clutch Racks ready for Heat Treating. The fixtures Testing & Evaluation pieces have shipped. Blades a Tear it up Tuesday! Get after it! 💪⚙️🇺🇸 #flywheel The Fellows 7125A Special Construction is reassemb Fellows Table Relieving Angle Guide Block reground Practicing my Flaking before doing it for real on Freshening up the table relieving angle blocks of Some times you have to perform maintenance. Becaus Churchkey+ & Churchkey+MINI proto v1.0 handles are With gratitude to those that have served (and are Some years ago I started doing this and it has pai Blades for the Churchkey+ are coming soon. If you’ Fluid Flow Friday. Izzatta thing? Used to be a thi Hobbing some Splines. These get a tooth removed fo Load More... Follow us on Instagram!
